Pressing the Quick key during exit will shorten the exit time to 3 seconds. Setting the system with Mains Fail In the event of a short term power cut, where it is known when power will be restored, e. Tamper Resetting With the display showing: Enter a valid User code. If Anti has been programmed for Alarm Reset, contact the Central Station or Engineer, as instructed by the Installation Company and quote the number given by the display. If Alarm Reset has been programmed for Master, then the display will show, for example, each time the User attempts to set! If a Master Code Reset has been programmed by the engineer, a higher level of code will be required. Your installation company will have informed you as to the type of reset that your system is set for. Your installation company will have programmed the reset modes for your system so that it complies with your insurance company and legislation requirements. Resetting After an Alarm After an alarm the system needs to be reset. If an alarm occurs when the system is set, the cause of the alarm will be displayed for 10 seconds after you unset the system. Proceed to the keypad and enter a valid User Code. Enter the premises via an authorised Entry Point. Enter a valid User Code followed by 2 or 3. Part 2 is a second set of zones that may be omitted and Part 3 will combine Part 1 and Part 2. Two other Part Sets may be available for your system. The display will show, for example: Part Setting the System using Part 2 or 3. At the start of the setting procedure, a fault Exit Now!

Eurosec CP8L User ManualĮxit the premises via an authorised exit route. After checking the premises are secure: Enter a valid User Code followed by. The bottom line of the display will then be blanked off.įull Setting the System. Set or Unset Status will only be displayed for ten seconds when the system is Set or Unset. Throughout this manual, reference will be made to the Master User Code, the factory set default is Display Status Blanking Depending on Control Panel installed, it may be a requirement that the Status Set or Unset display of the security system is not displayed.

Several user programmable options are available that will be covered later in this manual.

Your installation company will have programmed your system to protect your premises to the highest possible standards. Introduction Welcome to the eurosec control panel. View and Download Eurosec CP8L user manual online. Wire the LCD RKP as shown in the wiring section of this manual. The eurosec control panel is supplied as a blank fronted end station.

Throughout this manual refer- ence will be made to the User Code, the factory set default is This code is programmable along with eight other User Codes.

Eurosec pr5208 rev1.0 user manual